Health & Safety; Guarantee; Unit Location; Mounting The Alertmaxx2 Unit - Delta Membranes AlertMaxx2 Installation & Operating Manual

4.0 Health & Safety
In order to minimise the risk of ill health or accidents when installing and/or servicing pump chambers and
associated accessories, workers must be fully trained and competent. The following guidelines will help
safeguard matters:
• Assessing the risk and working in accordance with the control measures identified.
• Ensure electrical power to the equipment is isolated before carrying out installation or maintenance.
• A suitable first aid kit must be close to hand.
• The electrical installation must comply with the requirements of BS 7671:2008 'Requirements for Electrical
Installations' incorporating amendment 3:2015.
5.0

Guarantee

AlertMaxx2 is offered with a 24 month component guarantee. This guarantee only covers any defects in
workmanship, construction or material. This guarantee does not cover, defects caused by incorrect installation,
installer error, abnormal working conditions, misuse or neglect.
6.0

Unit location

The AlertMaxx2 must be positioned in an area where the alarm can be clearly heard and is permanently
accessible for servicing. The unit must be positioned where there is sufficient air circulation to the front and base
vents. The AlertMaxx2 must not be located further than 10m from the pump/s it is being used in conjunction
with. If cable extensions are required, these must be selected in accordance with BS 7671:2008 'Requirements
for Electrical Installations'. If using in conjunction with a PowerMaxx battery backup, please ensure the units are
no further than a 20m cable length from each other. The AlertMaxx2 should be positioned in an area where
there is a good Wi-Fi signal strength.
The AlertMaxx2 unit is not waterproof and must be installed indoors or inside a kiosk.
7.0

Mounting the AlertMaxx2 unit

1. Remove the screws from the front of the unit that secure the front fascia (the internal ribbon cable will be
disconnected on supply).
2. Using the 4 mounting holes provided, mark, drill and fit suitable wall plugs in to the chosen wall for
installation (ensure correct wall plugs are used for the wall type).
3. Secure the AlertMaxx2 unit to the wall using appropriate screws for the wall plugs used.
When securing the unit to the wall, avoid overtightening the screws as this may cause the box to crack.
CAUTION!
PLEASE NOTE
AlertMaxx2
5