Connecting External Devices; Energy Monitoring; Servicing; Spares - Delta Membranes AlertMaxx2 Installation & Operating Manual

AlertMaxx2

14.0 Connecting external devices

The AlertMaxx2 unit has volt free contacts to connect external devices such as an alarm or beacon. When the
alarm is activated the relay sends a signal continuously.
The volt free relay is designed to accept devices with a maximum load of 0.5A and voltage up to 30V. If external
devices fall outside these parameters, the device must be powered by an external power supply.
You can use the AlertMaxx2 to power external devices with a maximum voltage of 6-7V.

15.0 Energy monitoring

The AlertMaxx2 monitors energy consumption from the pumps. This is measure in kWh and is viewable by
pressing the FUNC button for 1-2 seconds. If there are two pumps connected, the screen will alternate between
two figures showing each pump.

16.0 Servicing

The AlertMaxx2 will alert home owners when their pump station requires servicing. This is indicated by an S1
error code followed by one beep every minute. The beep can be muted by pressing the 'RESET' button (the
code will remain illuminated). The beep will return 7 days from pressing the 'RESET' button until a service
technician resets the alarm unit.
The AlertMaxx2 unit has a factory default service interval of 12 months.
Code
Pump Station Service Required
S1
Battery Replacement
S2
(AlertMaxx2)
Battery Replacement
S3
(Hi-PowerMaxx, if installed)

17.0 Spares

Part No.
DMS-194
DMS-275
12
Fault
Pendant float switch
Rechargeable 6V battery
Your pump station requires a service. The
AlertMaxx2 will beep every minute. Please contact
PPS to arrange a service visit.
The battery in the AlertMaxx2 needs to be replaced.
Please contact PPS to arrange a service visit.
The battery in the Hi-PowerMaxx needs to be
replaced. Please contact PPS to arrange a service
visit.
Description
Action