Using The 5 Solenoid Torch Manifold; Converting Iefc-S Gas Console Manifold To Accommodate A; Solenoid Torch Manifold - ESAB Precision Plasmarc IEFC-S PT-24 Installation, Operation And Maintenance Manual

SECTION 3
3.20 Using a 5 Solenoid Torch Manifold
3.21 Converting IEFC-S Gas Console Manifold to Accommodate a 4 Solenoid Torch
Manifold
4
Gas Console Manifold
1
Argon inlet connection
2 Argon Solenoid
3 Marking Conversion Access 1/8 NPT
4
Air / Argon manifold outlet
3-19
NOTICE
3
2
PT-24 Precision Plasma with IEFC-S Consoles
The 5 solenoid torch manifold allows 1 second
conversion from cutting to marking and back to
cutting compared to 7 to 10 second switching
delay.
The IEFC-S is shipped configured to use the 5

solenoid torch manifold.

Marking with the PT-24 torch and the IEFC-
S does not utilize a proportional valve to
regulate Argon pressure. An external
regulator for the argon supply must be set
to 85 PSI (5,6 bar). See marking process
data for more information.
The gas console manifold is setup to accommodate
1
a 5 solenoid torch. Some modification is required
to permit marking with the IEFC-S and a 4 solenoid
torch.
Ar
INSTALLATION