Fujitsu ETERNUS AF Configuration Manual page 28

Chapter 8 Setting Up XenServer
8.5 Setting the Multipaths
For XenServer 5.5 and 5.6
•
Define the settings at the end of the "/etc/multipath.conf" file ("/etc/multipathenabled.conf" for Xen-
Server 5.6GA and earlier) as shown below.
devices {
The parameter for "product" varies depending on the model to be used as detailed in the following ta-
ble:
ETERNUS DX/AF to be connected
ETERNUS DX60 S2/DX80 S2/DX90 S2
ETERNUS DX400 S2 series
ETERNUS DX8000 S2 series
3
Enable multipath.
(1)
Select [Server] from the XenCenter menu bar and open [Properties].
(2)
Select [Multipathing] in the [Properties] screen, check "Enable multipathing on this server", and
click the [OK] button.
4
Release the maintenance mode, and then reboot the server.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Citrix
device {
vendor
product
prio_callout
path_grouping_policy
path_selector
failback
no_path_retry
path_checker
}
}
Copyright 2017 FUJITSU LIMITED
"FUJITSU"
"ETERNUS_DXL"
"/sbin/mpath_prio_alua %d"
group_by_prio
"round-robin 0"
immediate
10
tur
"product" value
ETERNUS_DXL
ETERNUS_DX400
ETERNUS_DX8000
28
® ®
XenServer
P3AM-4572-19ENZ0