Fluke 281 User Manual page 144

281, 282, 284
Users Manual
16-26
QER?
REFCLK <cpd>
SCMLEVEL <nrf>
SETUPCH <nrf>
SEQCNT <nrf1>,<nrf2>
SEQSEG <nrf>,<cpd>
SEQSTEP <nrf>,<cpd>
SEQWFM <nrf>,<cpd>
SUM <cpd>
SUMATN <cpd>
SUMRATIO <nrf>
SWPCENTFRQ <nrf>
SWPDIRN <cpd>
SWPMANUAL <cpd>
SWPMKR <nrf>
SWPSPACING <cpd>
SWPSPAN <nrf>
SWPSTARTFRQ <nrf>
SWPSTOPFRQ <nrf>
SWPSYNC <cpd>
SWPTIME <nrf>
SWPTYPE <cpd>
Query and clear query error number
register.
Set the ref. clock BNC connector to
<IN>, <OUT>, <MASTER> or
<SLAVE>.
Set the level for SCM to <nrf> Volts.
Select channel <nrf>
Set count for sequence segment <nrf1>
to <nrf2>.
Set the status of sequence segment <nrf>
to <ON> or <OFF>.
Set the 'step on' parameter for sequence
segment <nrf> to <COUNT>,
<TRGEDGE> or <TRGLEV>.
Set the 'waveform' parameter for sequence
segment <nrf> to <cpd>.
Set the sum source to <OFF>, <EXT> or
<PREV>.
Set the sum input attenuator to <0dB>,
<10dB>, <20dB>, <30dB>, <40dB>
or <50dB>.
Set the sum ratio to <nrf>.
Set the sweep centre frequency to <nrf>
Hz.
Set the sweep direction to <UP>,
<DOWN>, <DNUP> or <UPDN>.
Set the sweep manual parameters to
<UP>, <DOWN>, <FAST>, <SLOW>,
<WRAPON> or <WRAPOFF>.
Set the sweep marker to <nrf> Hz.
Set the sweep spacing to <LIN> or
<LOG>.
Set the sweep frequency span to <nrf>
Hz.
Set the sweep start frequency to <nrf>
Hz.
Set the sweep stop frequency to <nrf>
Hz.
Set the sweep sync <ON> or <OFF>.
Set the sweep time to <nrf> sec.
Set the sweep type to <CONT>, <TRIG>,
<THLDRST> or <MANUAL>.