Introduction; Storing And Recalling Set-Ups; Channel Waveform Information - Fluke 281 User Manual

281, 282, 284
Users Manual

Introduction

Pressing the UTILITY key calls a list of menus which give access to various system
operations including storing and recalling set-ups from non-volatile memory, error
messages, power-on settings and calibration.

Storing and Recalling Set-ups

Complete waveform set-ups can be stored to or recalled from non-volatile RAM using
the menus called by the store... and recall... soft-keys.
Pressing the store... soft-key (or the STORE front panel key, in the case of multi-
channel instruments) calls the store screen:
Nine stores are available, numbered 1 to 9 inclusive. Select the store using the rotary
control or direct keyboard entry and press execute to implement the store function.
Pressing recall... (or the RECALL front panel key) calls the recall screen:
In addition to the user-defined stores, the factory defaults can be reloaded by pressing the
set defaults soft-key. Note that loading the defaults does not change any arbitrary
waveforms, the set-ups stored in memories 1 to 9, or the RS232/GPIB interface settings.

Channel Waveform Information

Information about each channel's waveform memory can be viewed by pressing the
chan wfm info... soft-key:
For each channel selected (using the channel SETUP keys), the number of waveforms
and the free memory on that channel are shown.
14-2
Save to store No: 1
execute
Recall store No: 1
set defaults
execute
CHANNEL WFM INFO:
waveforms: 1
free mem: 65436
exit