AutoConnect AC200GPS3G Quick Start Manual

QUICK START GUIDE
Thank-you for your purchase!
You've made the decision to have full control of
your vehicle. Follow the steps below to begin a
new era of vehicle controls.
1.
Ensure you have the Serial # for your device.
2.
Visit our website and click on the "Activate" tab,
3. Select YOUR model number (device type) and
and fully complete forn
Once submitted you will receive a confirmation
email from Northsat Distribution with the details
of your device activation.
1 855 287 4477
TAKE CONTROL OF YOUR VEHICLES LIKE
NEVER BEFORE!
Start, Lock, Unlock, open your trunk (*AC200GPS3G Only)
Know the vital statistics of your vehicle(s)
Request a vehicle(s) Location On-Demand
Monitor vehicle(s) for Aggressive Driving and Excessive Idling
Know where your vehicle(s) went, and how they got there
ON ALL THREE MAJOR PLATFORMS
autoconnectgps.com
INSTALLER PORTAL
1
DETERMINE INSTALLATION TYPE
When installing an Autoconnect device you
must first determine the installation type.
The following pages will help you determine
the type and instructions for installation.
2
INSTALL YOUR AUTOCONNECT
GPS MODEM
Choose proper installation location ensuring to
follow instructions on install guide
Determine with customer if installation is to be
stealth (not visible)
Have label facing the sky and clear from any
metal above it.
Actual location will vary by vehicle year, make
and model.
TIP
WE RECOMMEND AFFIXING THE SID STICKER
TO THE DOOR JAMB OF THE VEHICLE
3
TEST THE DEVICE FUNCTIONS
TIP
Choose the proper IC3 Protocol if applicable
before sending any test commands
Click on the Customer Log-in
of any page of the autoconnectgps.com website
or download the free App for your mobile device.
Each Device comes with "TEST DATA" for you
to test all functions. This data will expire a few
days after installation.
Use the SID# for USERNAME and PASSWORD.
icon at the top
Username
Password
REV030617