Advertisement
XR-D400SL
Rewrite procedure
(1) Connect the REC/PLAY disc tray in the stand-alone mode to the
PC. (Fig. 5)
Note) The PC connection procedure will be described later.
(2) While holding down the switch on the right of the front panel
(encircled in Fig. 5), boot the PC.
(3) Keep holding down the above switch until Windows has started up.
(4) Run firmware software Download.exe.
(5) When the firmware software screen appears (Fig. 6), confirm that;
the Vendor is JVC, the product is XR-W4424 and the Version is 1.00.
Note) If another content than the above is displayed, restart the operation
from step (2).
(6) After confirming that the BUS Type is ATAPI and that Create is checked, click the Update
button. (Fig. 6)
(7) When the screen as shown in Fig. 7 is displayed, select Zcp133s.hex, and click the OK
button.
(8) The firmware rewriting starts and the access LED on the front panel changes from amber
lighting to amber blinking.
Rewriting takes about 60 seconds. The extinction of the access LED indicates the
completion of the firmware rewriting.
(9) When the screen in Fig. 6 is displayed again, click Close to close the firmware software.
Firmware version check procedure
(1) Boot the PC.
Note)If this procedure is started immediately after the rewriting procedure above, do not
simply restart the PC but be sure to switch it off and then on again.
(2) Open the Device Manager.
Click [Start] R [SettingR [Control Panel] R [System].
Select [Device Manager] and click [CD-ROM].
(3) When the screen shown in Fig. 8 is displayed, select JVC XR-RWD400S.
(4) Open the Properties of JVC XR-RWD400S and select Setting.
(5) Confirm that the firmware revision number is 1.33. (Fig. 9)
[Fig. 8]
1-14
[Fig. 6]
[Fig. 5]
[Fig. 7]
[Fig. 9]
Advertisement
