Using An External Power Supply W/Pz6 Or Phd12; Using An External Power Supply (No Pz6 Or Pz600) - Elan VHTO100 Manual

E L A N H O M E S Y S T E M S
Using an External Power Supply w/ PZ6 or PHD12
When exceeding current limits of the Z•600 (see p. 5) or when connecting the
VHTO100 to an HD system, it is necessary to connect a +12VDC power supply to
the front of a PZ6 or PHD12 Precision Panel to the location shown below. ELAN rec-
ommends the use of a PWR2 Power Supply for this purpose.
Note: The polarity of the VCO +12VDC jacks is reversed from that of many power
supplies. Use only power supplies with proper polarity!
PZ6 Front +12VDC Inputs
+12VDC INPUTS
+
Using an External Power Supply w/Z•600
Use a +12VDC power supply when current demands exceed limits shown previously.
Tie the Z•600 Control Output Jack's Blue conductor together with Wh/Blue. This will
go to VC+ of the VHTO100. Tie Wh/Green to Brown and connect to the + on the
power supply. Connect the - of the power supply to VC- on the VHTO100.
AMP OR
System Amplifier
VC-
© ELAN Home Systems 2005 • All rights reserved.
-
VCO
SPEAKERS
Rear Surround Speakers
Blue
VC+
Wh/Blue
Orange
Wh/Orange
Green
-
+
Wh/Green
+12VDC
Brown
Power
Wh/Brown
Supply
VHTO100
INSTALLATION MANUAL
PHD12 Front +12VDC Inputs
+12VDC INPUTS
VCO
+
SSP
Local Amplifier (SSP)
Z•600
CONTROL
OUTPUT
Z•025
-
(no PZ6)
Rear Channel
Speaker Outputs
Page 5