Vhto100 To Pz6 Connections; Vhto100 To Pz600 Connections - Elan VHTO100 Manual

E L A N H O M E S Y S T E M S
VHTO100 to PZ6 Z•Series Precision Panel Connections
Connect speaker cables from the ELAN system amp to the AMP terminals on the
VHTO100 and connect the rear channel speaker outputs from the local amplifier to
the SSP terminals on the VHTO100 as shown below. Connect the OR leads from any
of the PZ6's VC+ and VC- terminals to VC+ and VC- on the VHTO100.
Note: Refer to the Current Draw tables on page 5 to determine if an external
power supply is required to power the number of VHTO100s and Volume
Controls w/ Override to be installed.
AMP OR
System Amplifier
VHTO100 to PZ600 Communications Controller
Precision Panel Connections-S12
Connect the Volume Control Override signal from a PZ600 directly to the VC+ and VC-
terminals of the VHTO100 as shown below. See the PZ600 Installation Manual for
additional information.
AMP OR
System Amplifier
© ELAN Home Systems 2005 • All rights reserved.
SPEAKERS
VCO
VC-
VC+
VC-
VC+
VC-
VC+
VC-
VC+
PZ6 VCO Rear Surround Speakers
Connector
SPEAKERS
VCO
VC-
VC+
VC-
VC+
VC-
VC+
VC-
VC+
PZ600 VCO Rear Surround Speakers
Connector
VHTO100
INSTALLATION MANUAL
SSP
Rear Channel
Speaker Outputs
Local Amplifier (SSP)
SSP
Rear Channel
Speaker Outputs
Local Amplifier (SSP)
Page 3