Override Jumper Settings; Impedance Match Settings - Elan VHTO100 Manual

VHTO100
INSTALLATION MANUAL

Override Jumper Settings

The following adjustments are made by removing the four screws on the top of the
VHTO100 and pulling up the PC board/transformer assembly. There are no wires that
need to be disconnected. The volume of ELAN Page and Door Chime audio can be
adjusted by repositioning the Override Volume Jumpers (2). There are ten settings to
choose from: 1 is the lowest, 10 is the highest (Factory Default: 5).
Override
Volume
Jumper
Impedance
Match
Jumper

Impedance Match Settings

The VHTO has an impedance rating of 8 Ohms. The Impedance Match jumpers on the
VHTO allow you to connect it in parallel with other loads on the same amp channelsof
the ELAN System amplifier. It also allows you to connect multiple VHTOs to the same
amp channels. Impedance Match Jumper Settings: 1X, 2X, 4X (Factory Default: 4X).
8 Ohm
Speakers
VHTO100
System
Amplifier
Page 8
MIN
1
2
3
4
5
6
7
8
9
10
MAX
1X
2X
4X
2X Imp.
Match
© ELAN Home Systems 2005 • All rights reserved.
E L A N H O M E S Y S T E M S
MIN
1
2
3
4
5
6
7
8
9
10
MAX
1X
2X
4X
8 Ohm
Speakers
4X Imp.
VHTO100
Match
System
Amplifier
4X Imp.
Match
8 Ohm
Speakers
Override
Volume
Jumper
Impedance
Match
Jumper
4X Imp.
Match
4X Imp.
VHTO100
Match