Graco Pro 270GS Operation page 14

Airless sprayer
Table of Contents

Advertisement

Startup
Getting Started
Use a piece of scrap cardboard to practice these basic
spraying techniques before you begin spraying the sur-
face.
Hold gun 12 in. (30 cm) from surface and aim
straight at surface. Tilting gun to direct spray angle
causes an uneven finish.
12 in.
(30 cm)
even
finish
Flex wrist to keep gun pointed straight. Fanning gun
to direct spray at angle causes uneven finish.
even finish
Triggering Gun
Pull trigger after starting stroke. Release trigger before
end of stroke. Gun must be moving when trigger is
pulled and released.
Aiming Gun
Aim tip of gun at bottom edge of previous stroke, over-
lapping each stroke by half.
ti2038a
14
thick
uneven
ti5585a
finish
thin
thin
thick
thin
ti2036a
ti2037a
Unclogging Spray Tip
Do not operate or spray near children. Do not aim the
sprayer at, or spray any person or animal. Keep hands
and other body parts away from the discharge. For
example, do not try to stop leaks with any part of the
body.
Occasionally, debris from material can accumulate and
clog the spray tip. Perform the following steps to unclog
the tip.
1. To unclog tip obstruction, engage trigger lock.
2. Reverse spray tip to UNCLOG position.
NOTE: Trapped pressure in the gun and paint hose may
make the spray tip very difficult to turn. If so, perform the
Pressure Relief Procedure, page 8, before rotating
spray tip.
3. Aim gun at waste area, disengage trigger lock, Pull
trigger to clear clog.
ti11309a
ti9048a
ti11308a
3A2818A

Advertisement

Table of Contents
loading

This manual is also suitable for:

262866

Table of Contents