2.4
General safety information and protective measures
888331531
Note the safety information and protective measures!
Note the following points in order to ensure proper use of the samosPRO safety control.
ATTENTION
• Please follow the standards and guidelines valid in your country when installing and using
the samosPRO safety control.
• The national/international legal regulations apply to the installation and use of the safety
control as well as for the commissioning and repeated technical testing, particularly the
following:
– Machinery Directive 2006/42/EC
– EMC Directive 2014/30/EU
– Work Equipment Directive 2009/104/EC
– Low-Voltage Directive 2014/35/EU
– The accident prevention regulations/safety rules
– RoHS (Restriction of Hazardous Substances) Directive 2011/65/EU
• Manufacturers and operators of a machine on which a samosPRO safety control is being
used are responsible for coordinating with the proper authorities with regard to applicable
safety guidelines/rules and complying with these.
• The notices, particularly the test notices, must be observed without fail.
Further information:
The tests must be conducted by qualified persons or by those who are personally authori-
zed and commissioned to do so and must always be fully documented at all times by a
third-party.
• This manual must be provided to the operator of the machine on which the samosPRO sa-
fety control is being used. The machine operator must be trained by qualified persons and
is required to read this manual.
Wieland Electric GmbH | BA000966 | 08/2017 [8151]
Requirements for electric installation [ch. 7.1, p. 66]
Safety
13