Advertisement
Step 2: Continued
You will need for this page:
SB
(QTY: 4)
Overlap two (2) Side Wall Angles so that three (3)
4
holes align as shown. Insert one (1) Sand Bolt and Nut
through the center hole. Set aside for use in Step 10.
10706
5
Overlap two (2) Side Wall Channels so that three (3)
holes align as shown. Insert one (1) Sand Bolt and Nut
through the center hole. Set aside for use in Step 13.
10715
6
Repeat steps 4 & 5 to build a second set of each
assembly.
7
Check that the fi nished length of the assemblies is
94 1/8" ( 239,1 cm).
CHECK THAT ALL ASSEMBLED PARTS ARE
THE CORRECT LENGTH BEFORE CONTINUING
4
10715
Side Channel
Overlap parts so three
(3) holes align.
Place bolt and nut through
center hole only.
Overlap parts so three
(3) holes align.
Place bolt and nut through
center hole only.
4
10706
Side Angle
10706
Overlap Length
7 5/8" (19,4 cm)
16
10706
10715
10715
BUILD TWO (2) OF EACH
94 1/8" (239,1 cm)
Finished Length
16W
Advertisement
