E2: Means Short-Circuit Of The Sensor Or Unit Overheat; E3: Means “Overheating” - Kalorik Caiman EPCK 40911 Manual

Fax +1 305 430 9692
Make sure no condensation water stays in the housing cavity or in
•
the socket that could cause a short circuit. Make sure the
housing's cavity is dry. If the socket was ever immersed in water,
discontinue use and contact Customer service.
E2: means short-circuit of the sensor or unit overheat. In case of
overheat the unit is likely to display E3 (see below) then E2. This can
happen in some cases when the unit is heating without any water in
the cooking pot. If the case:
Add a little bit of water in the cooking pot
•
Let the unit cool down. The function should then be restored.
•
E2 might also appear when some foreign substance, food or liquids
are entering the socket at the center of the base, which creates a
short circuit. In this case, discontinue the use and contact Customer
service for maintenance/repair.
E3: Means "Overheating". When this happens:
Add a little bit of water in the cooking pot
•
Let the unit cool down. The function should then be restored.
•
If this E3 error message appears again on a regular basis, then
•
it is likely that the cooking pot or the heating plate inside the
base are deformed and create an uneven heat. The cooking
pot or the heating plate need to be replaced. Please contact
Customer service for maintenance/repair.
Copies of the I/B. Please reproduce them without any
changes except under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
20
Assembly page 20/32
special instruction from Team
Print only
EPCK 40911 - 160316