General Instructions For Installation In Custom-Made Furniture - ebios-fire Quadra Inside Automatic I SL Installation And Operating Manual

Suitable fasteners should be used for wall-mounting (e.g. wall dowels,
screws, etc.).
Modifications to the design or construction of the Quadra Inside Automatic I
SL oder II SL are NOT permissible.
2.6 GENERAL INSTRUCTIONS FOR INSTALLATION IN
CUSTOM-MADE FURNITURE
• When selling an ebios Quadra Inside Automatic for installation in a
custom-made piece of furniture, the installer must first accept and sign
the product information for this type of installation (refer to sections 7
and 8).
• The basic design of a custom-made piece of furniture for installation of
a Quadra Inside Automatic I SL oder II SL normally comprises at least
a top plate/tabletop and a housing space including the air supply. For
tabletop installation a housing space is not necessary, but it is advisable.
• When installing the fire in a custom-made piece of furniture (flammable
materials), it is essential to ensure that the Quadra Inside Automatic I
SL or II SL is NOT installed in a recess in the furniture. Fire hazard!
• The space above the Quadra Inside Automatic I SL or II SL must be clear
of all objects, all the way up to the ceiling (ceiling clearance >1,000
mm).
• The Quadra Inside Automatic I SL or II SL should only be installed in
the top plate or tabletop of a piece of furniture (for example: chest of
drawers, sideboard, pull-out unit, table).
• The furniture should always be permanently attached to the wall or floor
and secured against accidental moving, knocking over and/or lifting.
Suitable fastening material should be used.
• All air inlets and rear vents must be kept clear and never blocked, as
otherwise a build-up of heat may occur. Fire hazard!
GB 8