Remote Control Operation; Remote Playback; Erasing The Messages - Radio Shack TAD-1018 Owner's Manual

REMOTE CONTROL OPERATION

While you are away from your home
or office, you can use a touch-tone
phone or a pulse phone with a pocket
tone dialer to:
• Play your messages
• Erase your messages
• Set the answering system to an-
swer calls

REMOTE PLAYBACK

You must know your remote operation
security code to play back your mes-
sages from a remote phone. This
code (a 3-digit number) is on the bot-
tom of your answering system.
To play back your messages from a
remote phone, follow these steps.
1. Dial your phone number.
If is set to
RING SELECT
answering system answers on the
second ring if there are mes-
sages. If there are no messages,
the answering system answers on
the fourth ring.
2. After the outgoing message stops
and a beep sounds, enter the re-
mote operation
within 5 seconds. Be sure each
button press is at least
long. The answering
sounds a tone while the tape re-
winds. If no tone sounds, re-enter
the code.
Note: If you do not enter the code
within 7 seconds, the answering sys-
tem hangs up.
The answering system plays back the
incoming messages. At the end of all
the messages, the answering system
sounds single beeps and tones then
four short beeps.
Note: The answering system auto-
matically saves your messages after
remote playback.
To replay the messages, wait about 8
seconds after the four short beeps.
When you hear a single beep, enter
the remote operation security code
again.
ERASING THE
MESSAGES
, the
TS
If you want to erase the messages af-
ter playback, enter the remote opera-
tion security code within 8 seconds
after the four short beeps at the end of
all the messages. After the answering
system beeps, hang up the phone.
Note: After you erase messages by
security code
remote, you cannot recover them
(even if you press
1
/ second
2
you get back to your answering sys-
system
tem).
as soon as
SAVE
17