Mounting On A Wall Plate - Radio Shack TAD-1006 Owner's Manual

43-768.fm Page 10 Friday, August 13, 1999 2:49 PM

Mounting on a Wall Plate

1. Plug one end of the supplied mod-
ular cord into the
the back of the TAD-1006.
illustration
2. As shown below, press the modu-
lar cord into the right groove on
the mounting bracket and press
the AC adapter's cord into the left
groove.
illustration
3. Plug the other end of the modular
cord into the modular wall plate.
illustration
10
jack on
TO LINE
4. Line up the keyhole slots on the
bracket with the studs on the wall
plate, then slide the TAD-1006
down onto the wall plate until it is
secure.
illustration
5. Press up on the handset holder to
remove it, turn it over so its tabbed
edge faces up, then press it back
down into its slot on the base.
illustration