Mounting The Base On A Wall Plate - Radio Shack TAD-1029 Owner's Manual

43-789.fm Page 8 Monday, August 16, 1999 8:32 AM
4. Insert the supplied AC adapter's
barrel plug into the
the back of the base.
5. Route the adapter's cord through
the strain relief slot on the back of
the base.
Strain
Relief
Slot
6. Insert the tabs on the narrow end of
the bracket into the inner pair of
slots near the bottom of the base as
shown and snap the tabs at the wide
end of the bracket into place.
8
7. Plug the adapter into a standard AC
jack on
DC 12V
8. Fully extend the base's antenna and
Mounting the Base on a Wall
Plate
1. Remove the mounting bracket by
outlet. The message counter counts
down from 18 to 00
1029 beeps.
place it in a vertical position.
holding in both tabs and gently pull-
ing out the wide end of the bracket.
and the TAD-