Table of Contents
Advertisement
43-768.fm Page 11 Friday, August 13, 1999 2:49 PM
Mounting Directly on the Wall
To install the TAD-1006 directly on the
wall, you need a drill and two screws
(not supplied) with heads that fit into
the keyhole slots on the mounting
bracket.
1. At the desired mounting location,
drill two holes 3
one above the other.
illustration
2. Thread a screw into each hole
until the screw's head extends
about
1
/
inch from the wall.
4
illustration
3. Plug one end of the supplied mod-
ular cord into the
the back of the TAD-1006.
illustration
15
/
inches apart,
16
jack on
TO LINE
4. As shown below, press the modu-
lar cord into the right groove on
the mounting bracket and press
the AC adapter's cord into the left
groove.
illustration
5. Plug the other end of the modular
cord into a modular phone jack.
6. Line up the keyhole slots on the
bracket with the screws in the
wall, then slide the TAD-1006
down onto the screws until it is
secure.
illustration
11
Advertisement
Table of Contents
