MULTIQUIP J36H55 Operation Manual page 30

2. Place the engine ON/OFF switch in the ON position
(Figure 28).
ENGINE SWITCH
Figure 28. Engine ON/OFF Switch (ON)
3. Place the throttle lever in the IDLE position (Figure 29).
IDLE
THROTTLE
LEVER
Figure 29. Throttle Lever (Idle)
4. If starting a cold engine, place the choke lever in the
CLOSED position (Figure 30).
HONDA GX
CHOKE
LEVER
CLOSED
Figure 30. Choke Lever (Closed)
5. If starting a warm engine, place the choke lever in the
OPEN position (Figure 31).
PAGE 30 — J36/B46-M30 SERIES WALK-BEHIND TROWELS • OPERATION MANUAL — REV. #1 (11/17/17)
OFF
ON
ROBIN-SUBARU EX
CHOKE
LEVER
CLOSED
CLOSE
OPEN
HONDA GX
CHOKE
LEVER
OPEN
Figure 31. Choke Lever (Open)
6. Slowly pull the starter grip (Figure 32) until resistance
is felt, then pull briskly and smoothly to start the engine.
Gently return the starter grip to its original position.
STARTER GRIP
Figure 32. Starter Grip
7. If the engine has started, slowly return the choke lever
to the CLOSED position (Figure 30). If the engine has
not started, repeat steps 1 through 6.
8. Before operating the trowel, run the engine for several
minutes and check for fuel leaks and loose components.
CENTRIFUGAL SAFETY STOP SWITCH TEST
1. Clear the area around the trowel. Make sure it is free of
debris and objects.
OPERATION
ROBIN-SUBARU EX
CHOKE
LEVER
OPEN
CLOSE
OPEN