Set-Up - MULTIQUIP J36H55 Operation Manual

Float Disc Installation (Optional)
Float discs, or pans, attach to the trowel blades and allow
the trowel to float on wet concrete. The disc design allows
early floating and easy movement from wet to dry areas.
Float discs are also very effective for embedding large
aggregates and surface hardeners.
Installing Pans with Z-Clips
Refer to Figure 16 when installing pans onto trowel blades
using Z-clips.
Z-CLIP
TIE-DOWN
KNOB
FLOAT DISC/PAN
Figure 16. Float Disc Installation (Z-Clips)
1. Lift the trowel just enough to slide pans under the
blades. Lower the trowel onto the pans with the blades
adjacent to the Z-clips.
2. Rotate the blades into position under the Z-clips. Be
sure to rotate the blades in the operational direction
of travel, or use the engine to rotate the blades into
position.
3. Secure the blade tie-downs to the far side of the Z-clip
brackets with the tie-down knobs.
4. Make sure the blade edges are secured under the
Z-clips, and the tie-downs are secured completely over
the edges of the blade bar.
J36/B46-M30 SERIES WALK-BEHIND TROWELS • OPERATION MANUAL — REV. #1 (11/17/17) — PAGE 25
BLADE
TIE-DOWN
BLADE BAR
BLADE
Installing Pans with Latch Pins
Refer to Figure 17 when installing pans onto trowel blades
using latch pins.
BLADE STOP
BLADE
FLOAT DISC/PAN
Figure 17. Float Disc Installation (Latch Pins)
1. Lift the trowel just enough to slide pans under the
blades. Lower the trowel onto the pans with the blades
between the blade stops.
2. Fit the blades between the blade stops. Be sure to
rotate the blades in the operational direction of travel,
or use the engine to rotate the blades into position.
3. Route the latch pins through the blade stop holes.
4. Make sure the blade edges are secured between the
blade stops, and the latch pins are secured completely
over the blades.

SET-UP

LATCH PIN