Installation (Ez 4000 Cv) - Appliance Desk 4000 Service Manual

Inlet Hoses
The inlet hoses must be fitted with the special rubber washers. These rubber washers ensure a water tight
seal between the hoses and the water inlet valves to prevent water leaks. Water should flow freely into the
machine, be sure that the inlet hoses are not bent or kinked.
Please read the following steps carefully (Fig.1, Fig.2)
straight
1. Connect the
straight
2. Connect the
L-shaped
4. Connect the
the pressure-reducing valve if necessary). (Fig.2).
L-shaped
5. Connect the
to the pressure-reducing valve if necessary). (Fig.2).
Drain Hose
Connect the drain hose to a drain duct (with internal diameter of at least 1.6 inches) or place it for drainage
in to a sink or a tub, ensuring that there are no kinks or bends. The free end must be at a height of at least
24" from the floor (max 40"), the hose must be fixed in the appropriate hook on the upper part of the back
panel (see figure below).
U-Connector
The end of the outlet hose must be passed through the U-Connector (included). This creates an
upside-down U which is put into the drain pipe or over the edge of the sink. Failure to use the U-Connector
may cause the drain hose to pop-up during drainage of the water, which may cause water damage to the
surrounding area.

INSTALLATION (EZ 4000 CV)

end of the hot-water hose to the hot-water faucet (Fig.1).
end of the cold-water hose to the cold-water faucet (Fig.1).
end of hot-water hose to the inlet valve which has a red strainer. (Or connect to
end of cold-water hose to the inlet valve which has a white strainer. (Or connect
Fig.1
~ 5 ~
Fig.2