Update Software - Appliance Desk 4000 Service Manual

Introduce
The software of the display panel (DP) and the electronic module (EM) can be updated separately. The
updating work should be done by a qualified person.
The tools used to update software are figured below.
As showed in the above figure, the USB cable is used to connect the laptop and MINICUBE2 main unit, and
the target cable is used to connect the MINICUBE2 and the target device (such as DP, or EM).
The following figure shows the parts name of MINICUBE 2 main unit.
How to update the software?
1. Set the mode select switch to M2, and the power select switch to 5 on the MINICUBE2 unit.
2. Power off the washing machine, and unplug the communication cable from DP or EM.
3. Connect the laptop and MINICUBE2 using the USB cable. And connect the MINICUBE2 and DP or EM
using the target cable. The triangle mark on the target cable connector should be aligned with the
similar mark on the PCB of DP or EM (see figure below), in order to make sure to mate the connectors

Update Software

~ 19 ~