Table of Contents
Advertisement
The display board is affected with damp:
15.2
15.3
If not, replace a new display board.
How To Replace A New Display Panel?
Power off and unplug the unit.
Remove two screws and washers on the rear side of work top. Lift the work top up a little by
holding its rear side, and then push it towards the door to remove the work top.
Disassemble the front panel group by removing two screws and washers which assemble the
front panel on the cabinet, and two screws and washers which assemble the detergent box.
Unplug the communication cable.
Disassemble the display panel by removing five screws and washers.
Replace a new display panel, and then re-assemble it by following the reverse steps.
16.
Some notes or warnings with operation
16.1
To this washer/combo, the free end of drain hose must be higher than the water surface in
the sink, if it is not, the water in the sink will be siphoned in to the washer/combo after the
pump stops to work.
16.2
In dry cycle, please close the loading door firmly if the remaining time is not reduced, and
the washer/combo is not running.
16.3
If you have much condensing moisture in drum or have a poor dry result, please check the
cold water faucet is on.
16.4
If you have a poor spin result, it is because of heavy unbalance caused by over load or too
less laundry in drum.
16.5
In venting operation, there will be 5 minutes before the venting fan working, in order to
increasing the temperature quickly.
16.6
To get a good dry result, the combo would run a spinning cycle. The time of this spinning
cycle depends on the dry time the customer set (see the table below). If the customer
pause the running dry cycle and reprogram it by pressing the buttons of "Time +" / "Time
–", the new cycle will be started from the beginning.
Dry time (T)
T≥90 min
90 min>T≥60 min
T<60 min
Dry the display board, and test it again.
Spinning time (t)
t = 10 min
t = 5min
t = 0
~ 18 ~
Advertisement
Table of Contents
