Axis 2100 User Manual page 29

AXIS 2100 User's Guide
Sequentially Uploading Images to a Remote FTP Server
Ideal for busy Web sites on both large corporate networks, and SOHO (Small-Office
Home-Office) applications where a small network is installed and maintained; this
application uploads images to a designated FTP server on your network, and is perfect for
applications where a large audience is expected.
AXIS 2100
Simply install the AXIS 2100 directly on your local Ethernet network and complete the
Installation and Application Wizards to develop an active application that will upload
images to a designated FTP server - as a sequential stream that is unlimited or restricted to
specified time periods. You can organize the times and the frequency at which images are
taken and uploaded to the target FTP server. You can also decide to send images
sequentially via e-mail messages.
Installation and Configuration Overview
Configure the AXIS 2100 to actively upload images to an FTP server as follows:
1. Connect the AXIS 2100 to your local network. Refer to Installing Your Camera on a Network, on page 11.
2. Open the Home Page in your browser and start the Installation Wizard. Complete the Wizard to establish the standard
Security, Date and Time, Image General Layout and TCP/IP Network settings - selecting Network as your chosen method of
connection in the Modem or Network dialog. Refer to Configuring Your Camera, on page 20.
3. Continue the configuration of your product using the Application Wizard to define the target FTP server and your preferred
mode of operation - choosing Sequential mode to create your active application.
4. Having completed the Wizard, you should now verify the configuration by accessing the images stored on the FTP sever from
your browser.
Note:
You can refine your application using the Web-based Administration Tools.
LAN/WAN
Intranet Network
Choosing Your Application
Browser
Browser
29