Manual Control Of The Socket - Computherm Q1RX Operating Instructions Manual

button for approximately 2 seconds. Following this, the thermostat will
send, alternating every 5 seconds, switch-on and switch-off control
signals for 2 minutes (the signal appears and disappears alternately
on the display). When detecting the ON and OFF control signals, the
red LED light on the socket switches on and off, respectively. When it
fails to receive the signals sent by the thermostat, then it is outside the
transmission distance of the wireless (radio-frequency) transmitter,
thus they have to be placed closer to each other.

5. MANUAL CONTROL OF THE SOCKET

Pressing the "MANUAL" button separates the thermostat from
the socket. In this case, the device (e.g. pump) connected to
the socket can only be turned on and off manually, without any
5