Ericsson R250d PRO User Manual page 23

Dual band, tri mode for tdma systems
Hide thumbs Also See for R250d PRO:
Table of Contents

Advertisement

Call Receive is still shown in the display, and you
can still answer the call by pressing any key except
Unanswered Calls
Your terminal's display shows the number of calls you
have received but did not answer. You can clear the
number from the display by pressing any key or by turn-
ing the terminal Off.
If Caller Number Identification (CNI) is available from
your service provider, unanswered calls will be stored in
the ReceiveLog section of the
You can delete a number from the Last Dialed list by
pressing and holding
the display.
While On a Call
Using Speakerphone Submode
While on an active call in Phone Mode, the terminal will
switch to Speakerphone if the mode button is released
(up). The terminal will provide high speaker volume.
Audio is full duplex allowing you to talk and listen at the
same time.
Using Private Submode
While on an active call in Radio Mode, the terminal will
switch to Private Submode if the mode button is pressed
Basic Operations
.
NO
Menu.
86GGÃ96U6
while the number is shown in
CLR
down. The terminal will operate the same as it does in
Phone Mode conversation.
Increasing or Decreasing Volume During a Call in Phone
Mode
To increase the speaker volume during a call, press the
upper key on the side of your terminal. To decrease the
speaker volume during a call, press the lower key on the
side of your terminal.
Muting the Microphone During a Call in Phone Mode
To mute the microphone during a call, press
second or longer. Mic Muted is shown in the display.
Press
again (for one second or longer) to return to
CLR
your call.
Call Waiting
If you have call waiting service from your system, press
to answer a call when you receive the call waiting
YES
signal. You can switch between the two calls by pressing
. Do Not press
YES
calls.
Radio Mode Volume Control
To increase or decrease the speaker high-level volume
while you are in Radio Mode, rotate the volume control
knob. Rotate the knob clockwise to increase volume and
counterclockwise to decrease volume.
for one
CLR
until you are ready to end both
NO
19

Advertisement

Table of Contents
loading

Table of Contents