Voltage Regulators - Peak Electronics DCA75 User Manual

Atlas DCA Pro User Guide

Voltage Regulators

Voltage regulators are available in many different types and
different packages.
The DCA Pro is able to identify many types of regulator,
typically regulators with outputs less than 8V, depending on
current requirements.
Voltage Regulator
Red-IN Green-OUT
Blue-GND
V O U T =5.024V
I Q =2.54mA
V DO =1.83V
The displayed drop-out voltage (V
between input and output of the regulator to enable voltage regulation
to take place. Common regulators have a drop-out voltage of around
2V. Many "Low drop-out" regulators may have a drop-out voltage of
0.5V or less. The DCA Pro measures drop-out at very low load
currents on the regulator's output (typically less than 1mA). The drop-
out voltage of a regulator increases significantly with load current.
Some voltage regulators are not stable when used outside of their
intended circuitry (decoupling capacitors, proper loads etc). The
DCA Pro may not be able to identify the regulator correctly if it is not
stable during analysis.
When a regulator is identified, its
pinout, output voltage, quiescent current
consumption and drop-out voltage are
displayed.
Negative voltage regulators (such as
the popular 79L05) will be shown with
a negative V
) is the voltage that is required
DO
Page 28
April 2015 – Rev 1.4
figure.
OUT