CORBY INSTALLATION GUIDE
CBYR
32 & CBYP
HB32 - PENINSULA TABLE WITH HIGH BASE (HB) PEDESTAL 32"D
xx
xx
NOTE: Open and assemble only one product at
a time to avoid a potential mix-up of parts and
hardware. It is advisable to assemble the unit on
a clean padded surface to avoid scratches.
CAUTION: Do not drag the assembled furniture
across the floor. Lift the unit completely off the
floor, and move it to the desired location.
ASSEMBLY
STEP 1: Remove the drawer from the pedestal, if any.
STEP 3: Type of configuration
FLUSH CONFIGURATION
STEP 4: Place the peninsula table on the pedestal to align the two (2) drilled holes in the pedestal with the two (2) inserts installed in the bottom of the worksur-
face. Install two (2) Phillips PH screws (1/4-20 x 1
FLUSH CONFIGURATION
STEP 5: Slide the drawers back into the pedestal, if any. The units are now assembled.
FLUSH CONFIGURATION
5
Required tools
Safety glasses
Bit #6 Phillips
Included hardware
Phillips PH screw
Washer plate
1/4-20 x 1
, Qty. 2
Ø 1/4", Qty. 2
1/4
) from the bottom of the pedestal top to the peninsula table.
1/4
Drill bit 10mm
Cordless drill/screwdriver
STEP 2: Four (4) predrilled holes in the pedestal top are provided.
Depending on the configuration (as shown in step 3) , two (2)
holes must be drilled all the way through the top of the unit.
OFFSET CONFIGURATION
OFFSET CONFIGURATION
OFFSET CONFIGURATION
Fluid leveler
globalfurnituregroup.com