Cbyrxx32 + Cbypxxlb32 - Peninsula Table With Low Base (Lb) Pedestal 32"D - Global CBYCTxxxxHxx Installation Manual

CBYR 32 & CBYP LB32 - PENINSULA TABLE WITH LOW BASE (LB) PEDESTAL 32"D
xx xx
NOTE: Open and assemble only one product at
a time to avoid a potential mix-up of parts and
hardware. It is advisable to assemble the unit on
a clean padded surface to avoid scratches.
CAUTION: Do not drag the assembled furniture
across the floor. Lift the unit completely off the
floor, and move it to the desired location.
ASSEMBLY
STEP 1: Clean the top surface of the pedestal with a damp cloth, followed by a
soft dry cloth in the direction of grain.
STEP 3: Attach the riser box to the peninsula table with Phillips PH screw (1/4-20 x 1
bottom of the riser box.
RISER BOX OPENING OUTSIDE
STEP 4: Flip the assembled peninsula table and the riser box and set them on the low base (LB) pedestal as the configuration requires. Apply moderate pressure
from the top of the peninsula table at least one minute for the pressure sensitive double sided tape to adhere.
FLUSH CONFIGURATION
STEP 5: The units are assembled. Adjust the glides to level the worksurface. (Only Riser box opening outside shown for demonstration)
FLUSH CONFIGURATION
globalfurnituregroup.com
Required tools
Safety glasses Bit #6 Phillips
Included hardware
Phillips PH screw Washer plate
1/4-20 x 1 , Qty. 2 Ø 1/4", Qty. 2
1/4
1/4
or
CORBY INSTALLATION GUIDE
Screwdriver #6 Phillips Cordless screwdriver
Double sided adhesive tape
Qty. 1
STEP 2: Place the peninsula table upside down on a clean padded
surface.
) and washer plate (Ø 1/4") . Apply double sided adhesive tape to the
RISER BOX OPENING INSIDE
OFFSET CONFIGURATION
OFFSET CONFIGURATION
Fluid leveler
Riser box ( Sold separately)
Qty. 1
4