Nav/Com/Transponder/Audio Panel; Adf Tuning (Optional); Dme Tuning; Enter A Transponder Code - Garmin G1000 Reference Manual

NAV/COM/TRANSPONDER/AUDIO PANEL

ADF TUNING (OPTIONAL)

Tune the ADF using the remote ADF control head.

DME TUNING

1) Press the DME Softkey.
2) Turn the large FMS to select the DME source field.
3) Turn the small FMS Knob to select the desired Nav radio.
4) Press the ENT Key to complete the selection.

ENTER A TRANSPONDER CODE

1) Press the XPDR Softkey to display the transponder mode selection softkeys.
2) Press the XPDR1 or XPDR2 Softkey to select the active transponder.
3) Press the CODE Softkey to display the transponder code selection softkeys,
for digit entry.
4) Press the digit softkeys to enter the code in the code field. When entering
the code, the next key in sequence must be pressed within 10 seconds, or
the entry is cancelled and restored to the previous code. Five seconds after
the fourth digit has been entered, the transponder code becomes active.

ACTIVATE ADS-B TRANSMIT

1) Press the XPDR Softkey to display the transponder mode selection softkeys.
2) Press the ADS-B TX Softkey to enable transmission of three-dimensional
aircraft position and aircraft heading.
3) Press the ADS-B TX Softkey again to disable transmission.

SELECTING A COM RADIO

Transmit/Receive
Press the COM1 MIC, COM2 MIC, or COM3 MIC Key (optional COM, if
installed) on the audio panel.
Garmin G1000 Cockpit Reference Guide for the Hawker Beechcraft C90A/GT/GTi
190-00664-02 Rev. B
Nav/Com/XPDR/Audio Panel
5