Controls And Display - Beast Hover-1 HY-X10 Operation Manual

CONTROLS AND DISPLAY

PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
TURNING YOUR DEVICE ON/OFF
Power On: Take your device out of the box and place it flat on the
floor. Press the power button (located on the rear of your device)
once. Check the LED indicator (located in the center of your device).
The battery indicator light should be lit, indicating the device is
powered on.
Power Off: Press the power button once.
This Model also has self-balance mode: To activate this mode, press
the power button twice when the scooter is on.
MAT SENSOR
There are four sensors under the foot mats on your Hover-1 Beast.
When the user steps off the scooter mats, it will automatically initiate
self-calibration.
When riding the scooter, you must ensure you are stepping on the foot
mats. Do not step or stand on any other area of your scooter.
Do not put items on the foot mats. Doing so will make the Hover-1
Beast turn on, and increase the probability of collision and cause injury
to people, riders, or damage the device.
The Hover-1 Beast may vibrate or spin in one direction, if weight and
pressure are applied to only one foot mat.
BATTERY INDICATOR
The display board is located in the middle of the Hover-1 Beast.
• Green LED light indicates the device is above 50 percent.
• Red LED light indicates the power is down to 10 percent or lower.
When the LED light turns red, please recharge the device.
RUNNING INDICATOR
When the operator triggers the foot mats, the Running Indicator LED
will light up, which means that the system enters the running state.
When the system has an error during operation, the running LED light
will turn red (for more details see SAFETY ALERTS).
6