Battery Replacement; Fcc Statement - Beast Hover-1 HY-X10 Operation Manual

BATTERY REPLACEMENT

The Hover-1 Beast comes with a replaceable lithium-ion battery. If you
are experiencing problems with your battery, please contact our
customer service department for steps on how to replace this battery,
This battery should only be replaced using the same model from the
same manufacturer listed below.
Battery Manufacturer: Shenzhen Elite Electronic Co., Ltd.
Battery Model: HY-CHH-1002U
To replace your battery, turn your Hover-1 Beast upside down, and
remove the two screws that hold your battery door in place.
Disconnect your lithium ion battery and remove it. Replace your
battery with a new battery provided to you from the Hover-1 support
team if required. Replace the battery door and affix the screws tightly.

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Please note that changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
FCC INSTRUCTIONS FOR A CLASS B DIGITAL DEVICE OR PERIPHERAL
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
21