Beast Hover-1 HY-X10 Operation Manual page 17

Dismounting your device can be one of the easiest steps, yet when
done incorrectly, may cause you to fall. To properly dismount, from a
stopped position, lift one leg up and set your foot back down on the
ground (STEPPING BACK). Then step off completely as described in
the following diagram.
WEIGHT AND SPEED LIMITATIONS
Speed and weight limits are set for your own safety. Please do not
exceed the limits listed here in the manual.
• Maximum Weight: 330 lbs
• Minimum Weight: 44 lbs
• Maximum Speed: Up to 7.45 mph
Try staying relaxed and focus on finding
your center of gravity to maintain full
control of your Hover-1 Beast.
WARNING
Make sure to lift your leg completely off
the foot mat to clear the device when
stepping back to dismount. Failure to
do so may send the Hover-1 Beast into a
tailspin.
If the Hover-1 Beast is not placed on a level
surface, an alarm will sound and the warning
indicator will light up and prevent the Hover-1
Beast from moving. Place the Hover-1 Beast
on a level surface and try riding it again.
NOTES:
NOTES:
15