Battery Care / Maintenance - Beast Hover-1 HY-X10 Operation Manual

CHARGING YOUR Hover-1 BEAST
CHARGING THE DEVICE
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet.
• Connect the cable with the power supply (100V ~ 240V; 50, 60 Hz).
• Align and connect the 3-pin charging cable into the charging port
of the Hover-1 Beast. DO NOT FORCE OR BEND THE CHARGING
CABLE INTO THE CHARGING PORT, AS IT MAY CAUSE THE PRONGS TO
BEND OR BREAK.
• The charging indicator light should change to RED, indicating that
your device is now being charged.
• When the RED indicator light on your charger turns to GREEN, then
your device is fully charged.
• A full charge may take up to 2.5 hours.
• After fully charging your Hover-1 Beast, unplug the charger from
your device and from the power outlet.

BATTERY CARE / MAINTENANCE

BATTERY SPECIFICATIONS
Battery Type: Rechargeable lithium-ion battery
Charge Time: Up to 2.5 hours
Voltage: 36V
Initial Capacity: 4.3 AH
Working Temperature: 32°F - 104°F
Charging Temperature: 50°F - 77°F
Storage Time: 1 year
Storage Temperature: -4°F - 77°F
Storage Humidity: 5% - 95%
BATTERY MAINTENANCE
The lithium-ion battery is built into the device. Do not disassemble the
device to remove the battery or attempt to separate it from the
device.
• When charging the device, please use the enclosed 3-pin
charging cable or otherwise ensure that the battery charging
conditions are met.
• Do not connect or attach the device or the battery to a power
supply plug or directly to a car's cigarette lighter.
• Do not place the device or batteries near a fire, or into direct sunlight.
Heating the device and/or the battery can cause additional heating,
19