Initial Settings - YOKOGAWA UM330 User Manual

<Toc>
2.

Initial Settings

This chapter describes examples of setting the types of PV input and alarm. Carry-
ing out settings described herein allows you to perform basic monitoring. Refer to
examples of various settings to understand how to set parameters required. Refer to
"5.1 Parameter Map" for an easy to understand explanation of setting various
parameters. If you cannot remember how to carry out an operation during setting,
press the
ing display) that appears at power-on.
Setup Procedure
Power-on
Set PV input.
Set the alarm
type and other setup
parameters.
Set the alarm
setpoints and other
operating parameters.
Indicator operation
The following explanation of operation for the UM350's panel, shown in the figure, is the
same as that of the UM330's panel.
key for more than 3 seconds. This brings you to the display (operat-
SET/ENT
(Factory-set to "Unspecified.")
See "2.2 Setting PV Input Type (Setting First at Power-on),"
or "2.3 Changing PV Input Type."
See "2.4 Changing the Alarm Type."
See "3.2 Setting Alarm Setpoints."
<2. Initial Settings>
Denotes a step that must always be followed.
Denotes a step that should be followed as necessary.
IM 05F01D02-41E 1st Edition : May 31,2000-00
2-1