Table of Contents
Advertisement
MOUNTING THE UNIT TO A WALL
Secure the controller to the wall using the included mounting clips and screws.
MOUNTING THE UNIT TO A GROW TENT
Secure the controller to one of the grow tent's vertical support rods with the included U-bolt
brackets.
1. Install on the inside of the grow tent.
2. Install on the outside of the grow tent (note that this method requires puncturing four holes
through the grow tent wall to allow the threaded ends of the U-bolts to emerge through the
grow tent's fabric wall).
MOUNTING INSTRUCTIONS
1
10
2
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ECLIPSE F90 and is the answer not in the manual?
Questions and answers
Will it mess with the probe if it is close to a AC or exhaust **** or heater or will it not bother it accuracy and any information would be great thank you
The Autopilot ECLIPSE F90 probe is designed to resist EMI/EFI from electronic ballasts, but there is no specific mention of resistance to interference from an AC unit, exhaust, or heater. However, placing the probe too close to such devices could potentially impact its accuracy due to sudden temperature or airflow changes. It is recommended to position the probe in a stable environment for the most accurate readings.
This answer is automatically generated