Multiline Ip Terminal Programming Interface - NEC DT820 Quick Install Manual

Multiline IP Terminal Programming Interface

This section describes how to access the administration programming interface for Multiline IP Terminals. The
following describes how to gain access to the Admin Menu.
1. From a Multiline IP Terminal, press the following button sequence, HOLD + Transfer + * + # to enter
program mode. The Admin Menu login screen is displayed.
2. At the Admin Menu login screen, enter the default User Name and Password for the Multiline IP Terminal.
Use the BK soft key to remove an entered digit, Set soft key to switch between fields, Cancel soft key to
cancel the login, and press the OK soft key when ready to continue.
NEC SL2100 Communication System
DT820 Terminals Only an LLDP discovery request is sent to the
network and if supported by the network switch, configuration details of
the network such as VLAN and QoS configuration can be obtained by
the terminal.
A DHCP request is sent to the network to obtain IP configuration details.
DHCP can also be used to provision the SIP Server address information
but that is not covered in this Quick Start Guide. Please refer to the
SL2100 Networking Manual for further information.
The Terminal will by default normally display a 'SIP Server Not Found'
message.
If the Terminal does not display this message and connects to the
SL2100, it is most likely that the DHCP server has been configured to
provision the SIP Server address details already.
Programming Option
User Name
Password
8IPLD
Quick Install Guide – SL2100 Multiline IP Terminals rev 1.1
Default
ADMIN
6633222
DT820 8LDX
19