JLG 600SJC Service And Maintenance Manual page 163

1. Install seal (12) in motor housing (2). Use the correct
retaining ring pliers in order to install retaining ring
(11).
2. Install cradles (13) in motor housing (2).
3. Install pilot valve (10) on block assembly (9).
3120794
SECTION 6 - UNDERCARRIAGE PRIOR TO S/N 0300070975
4. Position block assembly (9) on motor housing (2).
Install four bolts (8). Tighten the bolts to a torque of
9 ± 4 ft.lb. (12 ± 5 Nm).
5. Raise the temperature of bearing (7). Install bearing
(7) on shaft (6).
6. Install shaft (6) in motor housing (2).
7. Use tooling (A) to install swash plate (4) in motor
housing (2). Install piston rod (5).
– JLG Lift – 6-39