Universal Audio OX Operation Manual page 17

POWER Input (10)
Caution:
Connect only the included external power supply to the POWER
input. Using a different power supply could damage OX and void the
warranty.
This 4-pin locking XLR jack accepts the DC output plug from OX's included external
power supply. OX requires 12 volts DC power and its power supply draws approximately
18 Watts.
Connect the included IEC power cable to the inlet of the included external power supply
and an AC power outlet.
Note: The following statement is provided for electrical compliance conformity:
"The POWER input is the primary disconnect device."
Wi-Fi Status LED (11)
This LED indicates activity on OX's built-in WI-Fi network. The LED states encountered
during normal operation are listed in the table below. For instructions on how to use OX's
Wi-Fi networking, see OX Software.
Note: If Wi-Fi LED states not listed below are encountered, please contact UA
Technical Support.
Wi-FI LED
State
Off
Blue (solid)
Green (solid)
Green (blinking)
Reset Switch (12)
This small pushbutton switch is used to reset OX's Wi-Fi settings and reset OX to factory
defaults. For more information, see Troubleshooting.
Note: Reset is not necessary during normal operation.
OX Amp Top Box
Indication
No network connection
Hotspot connection
External network
connection
Attempting external
network connection
No device is paired with OX's internal Wi-Fi hotspot
and OX is not paired with external Wi-Fi network
Device is paired with OX's internal Wi-Fi hotspot
OX is paired with external Wi-Fi network
OX is attempting to pair with external Wi-Fi network
that was selected in OX app
17
Notes
Controls & Connectors