Universal Audio OX Operation Manual page 14

RIG LED (2)
The LED beneath the RIG knob illuminates to indicate certain operating conditions. The
LED states encountered during normal operation are listed in the table below.
Note: If RIG LED states not listed below are encountered, please contact UA
Technical Support.
RIG LED State
Off
Green (solid)
Amber (solid)
Amber (blinking)
Green (blinking)
awaiting user confirmation
Factory reset initiated and
Red (blinking)
awaiting user confirmation
ROOM (3)
The ROOM knob adjusts the amount of mic'd studio ambience and air. Increase this
knob for more room ambience, or decrease for a drier close-mic tone.
When ROOM is adjusted, the RIG LED illuminates in amber, indicating the ROOM
amount is different than the value stored in the active RIG preset.
ROOM sounds are heard in the LINE / MON, HEADPHONE, and S/PDIF outputs, but not
in the TO SPEAKER output.
Tip: ROOM settings can be edited and stored with the OX software app.
OX Amp Top Box
Indication
OX not powered
RIG not modified
RIG modified
Firmware update
Wi-Fi reset initiated and
Rear panel POWER switch is in down position and/
or AC adapter is not properly connected
Active RIG has been loaded via RIG knob or OX app
and is unchanged from stored version
Active RIG has been edited via ROOM knob or OX
app and is not stored
Firmware update is in process
Press reset switch again within 10 seconds to
confirm Wi-Fi reset
Press reset switch again within 10 seconds to
confirm factory reset
14
Notes
Controls & Connectors