Resetting Network Settings - Bosch ARD-FPBEW2-IC Installation Manual

24
en | Installation
3.6

Resetting Network Settings

1. Turn the power on.
2. Press the network reset button on the rear of device until the
device restart automatically.
3. Connect the device with default values.
3.1 TCP/IP address: DHCP address assignment (If DHCP address
assignment is failed, 169.254.x.x will be set.)
3.2 Server mode: Disabled
3.3 RS-485: PC connection, 115200 bps
4. Change the TCP/IP address or RS-485 information.
5. Turn the power off later on and then check the network setting is
properly.
2018-02 | ARD-FPBEW2-IC |
FPBE W2 Fingerprint
Bosch Access Systems GmbH
Reader