Connect Power To The System - Samsung DCS-Compact II Installation Manual

DCS Compact II INSTALLATION MANUAL
Chapter 4. Power Up Procedures

4.1 Connect Power to The System

During the initial installation, it is best to verify proper system operation before
plugging in any amphenol-type cables to the MDF.
1. If you have already plugged the cables in, unplug them.
2. Verify that the AC voltage at the dedicated electric outlet is in the range 180 -
270 VAC
3. Make sure the AC power switch is in the OFF position and that the
MEM battery switch is OFF.
4. Plug the KSU power cord into the dedicated polarised AC outlet.
5. Turn the AC power switch to the ON position.
6. The AC and DC LED on the power supply will light steady to confirm
the presence of power.
If the PSU AC LED fails to light, unplug the system, remove the power supply and
check the AC fuse located on the bottom. If the fuse is good but the AC LED does
not light, check the AC outlet. If the AC outlet is also good, you must correct the
problem before continuing. To do this:
1. Turn off the power switch.
2. Unplug all cards using the card ejectors.
3. Turn the system on.
4. Check the AC LED again.
If the problem is corrected, you have a defective card. Test the line and option
cards one at a time to find the defective card and remove the card before
continuing. If the LED still does not light, unplug the KSU and change the power
supply. This should solve the problem. If it does not, contact your dealer for
advice.
Chapter 4. Power Up Procedures
4 - 1