The Mp6-Eva Evaluation Board; Safety Notice; Electrical Specifications Mp6-Eva Evaluation Board; Functional Elements - Bartels Mikrotechnik mp6 Operating Manual

7. The mp6-EVA evaluation board

The evaluation board enables the simple use of the mp6 based on the mp6-OEM controller. Next to preset
standard parameter (235 Vpp, 100 Hz) the mp6-EVA also allows to adjust the pump parameters, partly by
external tuning. As the supply voltage of the module can be provided via USB (no data interface), just
attach it to a USB power supply and start the evaluation. Alternatively it can also be supplied by a 2.5 – 5 V
voltage source.

7.1 Safety notice

The mp6-OEM generates voltages of up to 250 V peak to peak. All parts of the mp6-EVA evaluation board
can carry voltages in this range. Therefore the board should only be used by qualified personal. Although
the output power of the module is very low, proper insulation according to the application conditions needs
to be considered by the customer. This especially applies to the lower side of the PCB. Contact with water
or other liquids needs to be prevented. The pump must not be changed while a driving voltage is applied to
the board.
DANGER
THE EVALUATION BOARD CAN CARRY HIGH VOLTAGE !
BE CAREFUL, WHILE CONNECTING AND HANDLING THE BOARD!

7.2 Electrical specifications mp6-EVA evaluation board

As the evaluation board is based on the mp6-OEM module, all electrical characteristics and specifications
of this product must be considered. Please see chapter 6 of this manual for more details.

7.3 Functional elements

Elements are listed with their names according to the printed description on the PCB
Connectors:
CON 1 – Screw terminal for external power supply and external clock / amplitude signal
CON 2 – Solder terminal for extension cable to connect one mp6 micropump
CON 3 – Molex connector to connect one mp6 micropump
USB connector for voltage supply via USB
Bartels Mikrotechnik GmbH, Otto-Hahn-Str. 15, 44227 Dortmund, Germany
www.micro-components.com, microComponents@bartels-mikrotechnik.de
Tel: +49-231-9742-500, Fax: +49-231-9742-501
27