Bartels Mikrotechnik mp6 Operating Manual page 21

Step 1: Connect the control unit to your computer and turn it on.
Step 2: Start Windows Hyperterminal. Every new session has to be titled.
Step 3: Choose the com-port specified in the device manager.
Step 4: The connection-settings have to be (9600, 8, n,1).
Possible commands (followed by the enter key)
bon
boff
F(1-300)
F100
A(0-250)
A100,5
MS
MR
MC
(enter key)
The unit can also be used via LabView, Matlab or other programs. Using the unit with LabView, please
ensure that the "NI-Serial" package is installed. Normally the package is installed on yoursystem together
with LabView, but sometimes this option is skipped during install.
It can be downloaded on the National Instruments website:
http://joule.ni.com/nidu/cds/view/p/id/2316/lang/en
Afterwards it is possible to select the right COM-port for your mp-x in the VISA resource name.
On request we can send a package of LabView-Routines as an example of implementation. We do however
not offer a complete software environment for the use of the mp-x controller. Development of specific
software routines can be offered on request.
21
turns the micropump on
turns the micropump off
sets the required frequency between 1 and 300 Hertz:
...for example 100 Hertz.
sets the required amplitude between 5 and 250 Volt:
...for example 100,5 Volt. (in increments of 0.5 Volt)
sets signal form modus (S)ine
sets signal form modus (R)ectangle
sets signal form modus SRS
displays present settings of the control unit
Bartels Mikrotechnik GmbH, Otto-Hahn-Str. 15, 44227 Dortmund, Germany
www.micro-components.com, microComponents@bartels-mikrotechnik.de
Tel: +49-231-9742-500, Fax: +49-231-9742-501