Furuno FCV-288 Operator's Manual page 5

Warning Label
WARNING
To avoid electrical shock, do not
remove cover. No user-serviceable
parts inside.
Safety Instructions for the Installer
WARNING
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Be sure no water leaks in at the
transducer or sensor mounting
location.
Water leakage can sink the vessel. Also
confirm that the transducer and/or
sensor will not loosen by ship's vibration.
The installer is solely responsible for the
proper installation of the equipment.
FURUNO will assume no responsibility
for any damage associated with
improper installation of the transducer.
Use the specified power cable.
Use of other power cable can cause fire.
A warning label and a danger label are attached
Name: Warning Label
to the equipment. Do not remove these labels. If
Type: 02-166-1123-0
the labels are missing or damaged, contact a
FURUNO agent or dealer about replacement.
Name: Danger Label HV
Type: 02-166-1124-1
Name: Danger Label
Type: 02-166-1126-1
iii
SAFETY INSTRUCTIONS
CAUTION
Do not install the transducer or sensor
where air bubbles and noise are
present.
Performance will be affected.
The following are guidelines for
handling of the transducer cable.
- Keep fuels and oils away from the
cable.
- Locate cable in a safe place.
- Do not paint the cable.
The sheath of the cable is made of
chloroprene rubber (or polychloride
vinyl). For this reason do not paint the
cable.
Do not turn on the equipment with the
transducer out of water.
The transducer can be damaged.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
Display Standard
unit
compass
FCV-288 0.95 m
Steering
compass
0.60 m