1. Manuals
  2. Brands
  3. Truvox Manuals
  4. Vacuum Cleaner
  5. Hydromist 35
  6. User manual

Truvox Hydromist 35 User Manual

Hide thumbs Also See for Hydromist 35:
1
2
3
4

Advertisement

Table of Contents

See also: Instructions for Using
THIS USER GUIDE SHOULD ALWAYS BE USED IN CONJUNCTION WITH THE USER MANUAL

1. Preparing the machine

Fill the fresh water solution tank
with mixed water and approved
cleaning chemical according to the
chemical manufacturer's
instructions.

2. Using the machine

Fully unwind the supply cord and
plug in to a convenient socket
outlet.
Press and hold the solution switch
to apply the cleaning solution,
whilst pulling the machine slowly
backwards to clean the carpet.
UK-HM35-REV.00 (0218)
Hydromist 35 User Guide
To lower the floating brush, press
the foot pedal.
Stop spraying the cleaning solution
about 30cm before the end of the
cleaning pass to ensure all
solution is vacuumed up.
Switch on the vacuum motor,
pump and brush switches.
Wheel the machine forward and
repeat, slightly overlapping the
previous pass. Do not clean any area
more than twice, or overwetting
could result in carpets shrinking.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Hydromist 35 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Truvox Hydromist 35

Summary of Contents for Truvox Hydromist 35

  • Page 1: Preparing The Machine

    Hydromist 35 User Guide THIS USER GUIDE SHOULD ALWAYS BE USED IN CONJUNCTION WITH THE USER MANUAL 1. Preparing the machine Fill the fresh water solution tank with mixed water and approved cleaning chemical according to the chemical manufacturer’s instructions.
  • Page 2 When solution spray ceases the Make sure to empty the recovery After a few passes, check the solution tank is empty. Switch off tank when it is approximately ¾ waste tank to see that no foam is the machine, empty the recovery full.
  • Page 3 4. After use and storage 2 min After use, run the vacuum motor Ensure all switches are in the To drain the recovery tank, for approximately 2 minutes. OFF position. release the drain hose at the rear of the machine and empty into a bucket.
  • Page 4 Store the machine with the With both water tanks empty the Check the vacuum and brush for recovery tank lid removed and machine may be tilted backwards debris. The brush should be raised store in a dry indoor area only. to rest on the handle to facilitate for storage.

Table of Contents