Proflex RX680 User Manual page 6

RX680 Rowing Machine
5. Bring the rail (E) into position so it can be connected to the front of the damper unit (A). Plug the
damper unit and rail electrical connectors (K and L) together, then remove the tie wire (M).
Remove the lock knob (N) from the damper unit.
6. Slide the rail into the damper unit, so that the bolt holes on the sides are aligned. Insert the M10x80
screw (O) through the hole closest to the lock knob (the rail pivots around this screw), then secure
using the M10 nut (P). Tighten (rotate right) the nut, but leave a small amount of clearance
otherwise it will be difficult to fold the machine. Insert the locking pin (Q) through the remaining hole
and secure the rail with the lock knob (this is the unfolded position).
K L
M
7. Insert the foot board shaft (R) through the damper unit. Then, slide the foot boards (S) onto the shaft.
Secure each foot board using a M8 washer (I) and nut (T). Firmly tighten (rotate right) the fasteners
using the spanner.
R
8. Place the 2 rail cover (U) pieces in position at the end of the rail.
Attach the cover pieces together (upper holes) using 2 self-tapping
screws (V). Tighten (rotate right) the fasteners using the
screwdriver, however, be careful not to over-tighten as the
fasteners are screwing into plastic. Attach the cover pieces to the
rail (lower holes) using 2 M5 machine screws (W), and tighten
(rotate right) using the screwdriver.
9. Carefully pull the console (X) from the damper unit. Install 1 AA
battery (Y) (ensure that battery polarity is correct) at the rear of the
console. Re-insert the console until it "clips" into place.
X
The machine should resemble the image below and is
ready for use.
E&OE
A
8
N
8
E
8
Y
© 2017 Proflex
O
P
Q
S
I T
U
V
W
W
6