Power Supply Voltage; Motor Currents - Oriental motor CSK243-ATA Operating Manual

7.4 Power supply voltage

(Only for CSD2109-T, CSD2112-T, CSD2120-T)
Be sure to set the power supply voltage switch
(24/36V) according to the driver's power supply
input voltage.
Factory setting: 24V
• Set the switch to ON when the power supply
voltage is 24 VDC.
• Set the switch to OFF when the power supply
voltage is 36 VDC.

7.5 Motor currents

Set the motor currents during operation and in the current cutback state.
Motor operation current
Factory setting: Motor's rated current
If the load is small and there is sufficient torque, the operating current can be
reduced to suppress vibration and temperature rise of the motor.
Motor standstill current
Factory setting: 40% of motor operating current
Setting the motor operating current too low may affect the motor's
Note
•
starting characteristics and position retention performance.
Be sure to adjust the current within the rated current of the motor/driver.
•
Failure to do so may damage the motor/driver.
When setting the current at motor standstill, be sure to do so after
•
setting the motor's operating current and turning off the power supply to
the driver.
24/36V
ON
OFF
ON: 24 V
OFF: 36 V
7 Setting
−35−